6
en
5.1 Automatic operation with tilt function
The tilt function warns if any interference to the laser has
occurred that may cause misalignment. This ensures that
such interference does not go unnoticed.
This mode is always set directly after the unit is switched on.
In “Automatic” operation, the laser unit levels itself
automatically.
Place the laser unit in the appropriate working position
(vertical or horizontal). Press the button (ON/OFF) once.
The LAR 160 / LAR 160 G is in now in “Automatic operation
with tilt function”.
The automatic levelling process begins. Once levelling is
complete, the beam stays on constantly and begins to
rotate. Fine adjustments can still be made within the first
30 seconds. These 30 seconds are indicated by a slow
flashing of the white “TILT” LED.
After 30 seconds, the white “TILT” LED lights up steadily,
meaning the tilt function is active. If any event occurs that
could result in the laser unit being deflected from its exact
alignment and setting, the beam ceases to rotate. The
“TILT” LED flashes red. If this occurs, check the laser unit
and set it up once again if necessary.
You must press the “TILT” button to confirm the tilt function.
Only after this can you proceed further.
If you are working in conditions where interference is
present (e.g. on vibrating surfaces), it is recommended
that you select “Automatic operation with relevelling”.
5. Operating mode
30
sec
