background image

Carefully read and follow all safety instructions in
this manual or on pump.

This is the safety alert symbol

When you see this symbol on your pump or in this manual,
look for one of the following signal words and be alert to
the potential for personal injury.

warns about hazards that 

will

cause serious

personal injury, death or major property damage if ignored.

warns about hazards that 

can

cause serious

personal injury, death or major property damage if ignored.

warns about hazards that 

will

or

can

cause

minor personal injury or property damage if ignored.

The word 

NOTICE

indicates special instructions which are

important but not related to hazards.

1. Read these rules and instructions carefully. Failure to

follow them could lead to serious bodily injury and/or
property damage.

2. Check your local codes before installing. You must

comply with their rules.

3. Vent sewage or septic tank according to local codes.

4. Do not install pump in any location classified as 

hazardous by National Electrical Code, ANSI/NFPA
70-1984.

Risk of electrical shock. Can burn

or kill. 

Do not lift pump by power cord. See “Cord Lift

Warning” on Page 3.

Hazardous voltage. Can shock,

burn, or cause death

. During operation the pump is

in water. To avoid fatal shocks, proceed as follows if
pump needs servicing:

5A. Disconnect power to outlet box before pulling pump

cord plug. 

5B. Take extreme care when changing fuses. Do not stand

in water or put your finger in fuse socket.

5C. Do not modify cord and plug. When using cord and

plug, plug into a grounded outlet only. When wiring to
a system control, connect pump ground lead to system
ground.

6. Do not run pump dry. Dry running can overheat pump,

(causing burns to anyone handling it) and will void war-
ranty. 

7. Pump normally runs hot. To avoid burns when servic-

ing pump, allow it to cool for 20 minutes after shut-
down before handling it.

8. In normal service, motor should not need oiling. Motor

has been filled at the factory with a special oil; when
overhauling, replace with new oil. Use only oil speci-
fied in parts list of this manual. Use of any other oil
could damage motor and will void warranty.

STA-RITE

OWNER'S MANUAL

Installation • Operation • Repair Parts

Submersible Solids Handling Pumps

300EL, 400EL, 400S Series

STA-RITE INDUSTRIES, INC., DELAVAN, WISCONSIN 53115

Printed in U.S.A. © 2003, Sta-Rite Industries, Inc.

S311 

(Rev. 5/19/03)

SAFETY INSTRUCTIONS

Reviews: