![ST UM2898 User Manual Download Page 8](http://html1.mh-extra.com/html/st/um2898/um2898_user-manual_1355734008.webp)
5
How to run the single-phase smart meter
Step 1.
single-phase smart meter, connect it to the
, as
shown in the table and figures below.
Table 2.
STDES-EMETER1PV1 and ST-LINK/V2 pin connection
Signal
ST-LINK/V2 connector
STDES-EMETER1PV1 J21 connector
VCC
1
1
SWCLK
9
2
GND
10
3
SWDIO
7
4
NRST
15
5
Figure 6.
STDES-EMETER1PV1 and ST-LINK/V2 pins
(Dotted yellow lines identify pin 1 and pink dotted lines identify pin 5
Figure 7.
STDES-EMETER1PV1 and ST-LINK/V2 connection
Step 2.
AC
.
The power supply on the board converts the 220 V into 3.3 V to power the MCU.
Step 3.
Install
on your PC/laptop to program the MCU.
UM2898
How to run the single-phase smart meter
UM2898
-
Rev 1
page 8/31