Step 4.
Long push the
blue button until download starts.
Figure 91.
Starting the download
Step 5.
Refer to the Group Monitor panel to check KNX-RF communications during ETS download.
Figure 92.
KNX-RF communications during ETS download
Once
devices are programmed and reset, you can monitor KNX-RF communications through
ETS tool.
Figure 93.
KNX-RF communication monitoring
4.2
ETS5 setup through Tapko USB dongle
4.2.1
KNX-RF topology
Topology is based on Tapko KNX-RF RF/TP gateway as shown below.
UM2920
ETS5 setup through Tapko USB dongle
UM2920
-
Rev 1
page 49/71
