Introduction
The
Evaluation board is designed as a complete demonstration and development platform for
STMicroelectronics Arm
®
-based dual Cortex
®
‑
A7 32 bits and Cortex
®
‑
M4 32 bits MPUs in the STM32MP1 Series. It leverages
the capabilities of increased-frequency 800 MHz STM32MP1 Series microprocessors for the user to develop applications, using
STM32 MPU OpenSTLinux Distribution software for the main processor, and
software for the co-processor. It
includes an ST-LINK embedded debug tool, LEDs, push-buttons, one joystick, 1-Gbps Ethernet, CAN FD, one USB OTG Micro-
AB connector, four USB Host Type-A connectors, LCD display with touch panel, camera, stereo headset jack with analog
microphone input, four digital microphones, one SPDIF Rx/Tx, smartcard, microSD
™
card, and eMMC, NOR and NAND Flash
memories.
STM32MP157F-EV1, shown in
Figure 1
and
Figure 2
, is used as the reference design for user application development,
although it is not considered as final application.
To expand the functionality of the
Evaluation board, two GPIO expansion connectors are also available for
motor control and Raspberry Pi
®
shields.
An ST-LINK/V2-1 is integrated on the board, as embedded in-circuit debugger and programmer for the STM32 MPU and the
USB Virtual COM port bridge.
Figure 1.
STM32MP157F-EV1 top view
Figure 2.
STM32MP157F-EV1 bottom view
Pictures are not contractual.
Evaluation board with increased-frequency 800 MHz STM32MP157 MPU
UM2648
User manual
UM2648
-
Rev 1
-
June 2020
For further information contact your local STMicroelectronics sales office.
