Introduction
The
Evaluation boards (STM32MP157x-EV1) are designed as complete
demonstration and development platforms for STMicroelectronics Arm
®
-based dual Cortex
®
‑
A7 32 bits and Cortex
®
‑
M4 32
bits MPUs in the STM32MP1 Series. They leverage the capabilities of increased-frequency 800 MHz STM32MP1 Series
microprocessors for the user to develop applications, using STM32 MPU OpenSTLinux Distribution software for the main
processor, and
software for the co-processor. They include an ST-LINK embedded debug tool, LEDs, push-
buttons, one joystick, 1-Gbps Ethernet, CAN FD, one USB OTG Micro-AB connector, four USB Host Type-A connectors, LCD
display with touch panel, camera, stereo headset jack with analog microphone input, four digital microphones, one SPDIF
Rx/Tx, smartcard, microSD
™
card, and eMMC, NOR and NAND Flash memories.
STM32MP157x-EV1, shown in
, is used as the reference design for user application development,
although it is not considered as final application.
To expand the functionality of the
Evaluation boards, two GPIO expansion
connectors are also available for motor control and Raspberry Pi
®
shields.
An ST-LINK/V2-1 is integrated on the board, as embedded in-circuit debugger and programmer for the STM32 MPU and the
USB Virtual COM port bridge.
Figure 1.
STM32MP157x-EV1 top view
Figure 2.
STM32MP157x-EV1 bottom view
Pictures are not contractual.
Evaluation boards with increased-frequency 800 MHz STM32MP157 MPUs
UM2648
User manual
UM2648
-
Rev 2
-
November 2020
For further information contact your local STMicroelectronics sales office.
