UM0897
Running the system
Doc ID 17012 Rev 1
11/25
3 Running
the
system
3.1 Powering
up
The web client system works on a 5 V power supply. An adapter capable of supplying 5 V,
500 mA can be used.
1.
When the system working as "Web client with local display" is powered up, a menu will
be displayed on the TFT as shown in
. Three buttons appear on the menu:
–
IPCAM: This button is used if the user wants to monitor images from the IP
camera plugged in the network
–
Network: This button is used if the user wants to monitor images from the LAN
server present on the network
–
Config: This button is selected to configure the IP address of the HTTP web server
and the IP camera address.
Before going to either IPCAM or network mode please make sure that the IP address of
both the HTTP web server and the IPCAM are correct. Through displayed instructions the
user can navigate the menu and change IP addresses.
Note:
The HTTP web server address is the address of the machine where the HTTP server is
installed.
The IPCAM address is 10.199.131.2.
2.
As mentioned earlier, 6 keys are available for user interface. Once the board is powered
on, the TFT displays the message below.
Figure 8.
Initial display
3.
The LEFT and RIGHT keys are used to navigate between three buttons (IPCam,
network and config). During navigation the button will be highlighted in red. Use the
ENTER key to select the button.
4.
With the help of the configuration menu, the user can configure the IP address of the
servers to which it wants to connect. For example, the user can change the address of
the HTTP server to connect to other servers.
