UM2227
Getting
started
DocID030639 Rev 1
5/15
2
Getting started
2.1
Installing the drivers on host PC
To install the drivers on your PC, follow the procedure shown below.
No drivers need to be installed on the Bluetooth SPBT3.0DP1 module or the
evaluation board.
Step 1
Plug the STEVAL-BTDP1 into any available USB port: the computer will automatically
find the devices shown below.
Figure 2: USB drive installation first and second step
Step 2
A Found New Hardware Wizard installation window opens:
- select
Yes, this time only
to locate the drivers from the Microsoft
®
website
- click
Next
to confirm the installation of the identified STEVAL-BTDP1 USB to UART
controller and virtual COM port driver
Figure 3: Wizard installation - first step
