Figure 14.
GUI Settings menu
Some settings (e.g. GUI refresh rate or power averaging) can be changed in real-time.
Pressing the
Save Settings
button saves the settings into the
config.xml
file.
Table 2.
GUI setting parameters
Serial Port
UART Tx delay (ms)
Optional Tx Delay. Leave it to 0ms
UART speed (ATE mode)
STNRG011 UART speed during logging phase
UART speed (Normal mode)
STNRG011 UART speed during ATE mode
Log UART messages from
STNRG011
Option to log the UART exchange on a file (uart_trace.txt on the GUI executable directory)
STNRG011
M24C32 E2P address
Hardware address of the external E2P. STNRG011 is always assuming 4 (100)
ADC PFC_FB full scale
Full scale equivalent value of the PFC_FB pin which is the voltage expected at the bulk
capacitor when the voltage at the PFC_FB pin is at the ADC full scale (2.5 V). Keep this
value if you are using the standard resistive bridge divider (9 MΩ/46.7 kΩ)
Default paths
Patches path
Default path for the E2P patches
NVM path
Default path for the NVM settings
UM2342
GUI settings
UM2342
-
Rev 1
page 14/57
