24
To Use with Your TNS Device
LP0xxx Rev x
To connect your Programmer to your TNS, push the “Connect” button on the
Programmer. Move the Programmer magnet over the TNS in a circular motion. The
Programmer will chime when connection is made. You may then use the Programmer
to adjust your stimulation settings.
To quickly turn OFF stimulation, press the red button on the TNS for more than two
seconds or push the “Turn OFF all Stimulation” button on the Programmer screen.
To enable stimulation after pressing either button, you must connect with your
Programmer and turn the stimulation back on.
To Use with Your INS Device
1
2
3
4
To connect your Programmer to your INS, push the “Connect” button on the
Programmer. Move the Programmer magnet over the implant location in a circular
motion. The Programmer will chime when connection is made. You may then use the
Programmer to adjust your stimulation settings.
Cleaning your Programmer
To clean your Programmer, wipe carefully with a damp – but not wet – soft cloth. Do
not get the Programmer wet. Always follow the Precautions listed above. They instruct
you not to wash the Programmer or TNS. Excess water may keep them from working
properly.
Summary of Contents for Axium
Page 35: ......
