WWW.SSTCOMM.COM
31
Click "OK".
3.6 Restore to Default Configuration
Under current configuration, the PROFINET configuration of GT200-PN-RS does not support some compound
mode. Sometimes it will appear the phenomenon of configuration failure. When that condition happens, the network
LED is off, module LED red blinking (the same instruction as system startup). Now, you can't scan GT200-PN-RS
through SST-TS-CFG until restoring to the default configuration.
Specific steps are as follows:
a) Power off GT200-PN-RS;
b) Set bit 1 DIP switch to on and bit 2 to off;
c) Power on GT200-PN-RS, waiting TX LED of subnet
Ⅰ
be green on;
d) Set bit 1 of DIP switch to off in 5s, waiting TX LED be green off;
e) Set bit 1 of DIP switch to on in 5s, waiting TX LED be green on;
f) Restart GT200-PN-RS (power off and power on), GT200-PN-RS is now in configuration state.
Summary of Contents for GT200-PN-RS
Page 53: ...WWW SSTCOMM COM 53...
