User Manual
Modbus TCP/EtherNet IP Gateway
GT200-MT-EI
WWW.SSTCOMM.COM
16
4
）
Delete commands: Left click on the command to be deleted, perform the operation of deleting the
command.
5
）
Edit node: Left click the node needs to be reset, and then set parameters of this node in configuration
interface.
6
）
Copy node: Left click the existing node, choose the node and execute the operation of copying nodes
(include all commands under the node)
7
）
Paste node: Left click and choose any existing node, execute operation of paste node. Then at the Ethernet
rear part you can see a new node (include all commands under the node); Node parameters of new node is default
setting, it needs to be reset.
4.4 The Operation of Configuration Interface
4.4.1 EtherNet/IP Configuration View Interface
In the equipment view interface, click Ethernet/IP; configuration view interface is as below:
