SST Automation GT200-HT-RS, User Manual

Page: 34 / 52

WWW.SSTCOMM.COM 34
3. Click “Tool—Show Memory Data” or click on the icon , Interface is as follows:
As is shown in the table, upper table shows the memory distribution of HART input data, lower table shows
the output data. When you need to change the output data, click the “stop” button firstly, then change the related
data or load the already saved data table, at last, click the “sending data”.
4.2.9 Diagnose
Through this function users will know which device is not communicating, execution condition of configured
commands, data transmit of gateway and displays of certain command, operating steps are as follows:
1. Set the DIP switch’s debug bit to ON state and the configuration bit to OFF state, back online.
GT200-HT-RS is in the debug mode.
2. Use a serial port line to connect the GT200-HT-RS’s RS-232 port and computer RS-232 serial port or
use USB way to connect it, open the software “SST-HT-CFG”, Click “Config—Serial Connection”,
Select the correct serial port