SST Automation GT200-HT-RS, User Manual

Page: 33 / 52

WWW.SSTCOMM.COM 33
4.2.6 AutoMap
Automap will automatically distribute the memory with no conflict according to the input/output bytes
number by users’ commands.
You should set the correct input/output bytes for each commands, then click label, select “yes” in the
popup menu.
4.2.7 Download Configuration
Click the icon ; it will download the configuration into the gateway.
4.2.8 Memory Data Display
Show the data exchange inside of the gateway, users can use this function to debug the HART fieldbus in the
absence of the Modbus master station. Steps are as follows:
1. Set the DIP switch’s debug bit to ON state and the configuration bit to OFF state, restart the
gateway. GT200-HT-RS is in the debug mode.
2. Use a serial port line to connect the GT200-HT-RS’s RS-232 port and computer RS-232 serial port
or use USB way to connect it, open the software “SST-HT-CFG”, Click “Config—Serial
Connection”, Select the correct serial port