User Manual
Universal Serial/PROFIBUS DP Gateway
GT200-DP-RS
WWW.SSTCOMM.COM
11
4.2 Configuration
GT200-DP-RS V6.1 and higher versions support two configuration modes: DP Integrated Configuration mode and
Software Configuration mode.
The Software Configuration mode allows user to configure the GT200-DP-RS in SST-MPG-CFG software.
The DP Integrated Configuration mode allows user to configure all parameters of the GT200-DP-RS in
PROFIBUS integrated configuration software, such as STEP7 or TIA Portal.
Before starting the configuration, please check the configuration mode of the GT200-DP-RS.
4.2.1 Configure by SST-MPG-CFG Software
Reference the image below the step. In this example, the SST-MPG-CFG is of V1.3.3.
1. Download, install, and run the configuration software, SST-MPG-CFG, which can be found on the
GT200-DP-RS product page at sstcomm.com.
2. Click the upload button on the tool bar. The Upload Configuration will pop up, in this window select the
GT200-DP-RS gateway you wish to configure and click “Upload”.
Note: This will upload the default configuration in the software, this is also how you can edit your
configuration after downloading your configuration to the gateway. If you cannot find the gateway, check
your connections.
3. Click “Field Bus” located in the Equipment Section. Configure the parameters to meet the needs of your
project. Ensure that the PROFIBUS address matches your device’s address.
Note: If you select “Address setting using hardware” for PROFIBUS address, the PRIFBUS address is set by
Setting Button on the GT200-DP-RS (
). For more details of the PRODIBUS address, please see
.
