( 3 / 8)
Device use:
Digital dimmer DP1 is designed to fulfill all the requirements of most lighting applications – mainly in
TV or special scenarios when the one channel dimming it’s necessary. It’s equipped with 400us
Risetime chokes which guarantee very low lamp noise. The main benefit of DP1 is using special
Wireless DMX card inside which allows to use device without DMX cable, additionally you can use
DMX out connector as source of DMX signal for any other devices: color changers, other DMX
equipment, Device should be controlled via WDMX, DMX or ANALOG fader and the controlling is via
LTP rule. LTP: Latest takes precedence: change of one signal take controlling of output dimming
signal.
Device Front panel description
1.
DMX in / DMX OUT connector
Pin 1
GND
Pin 2
Data -
Pin 3
Data +
Pin 4,5
Not connected
2.
DMX start address and MODE selector switch
a.
DMX address : 0-9 switches : active on TOP
b.
MODE switch : 10 switch :
i.
DMX & ANALOG – dip switch in position 1 – TOP
ii.
WDMX & ANALOG – DIP switch in position 0 - BOTTOM
3.
ANALOG fader
i.
0-100% of output value
4.
POWER LED
i.
Solid GREEN – all OK
ii.
Blinking GREEN – Over temperature
iii.
Blinking fast GREEN – Under or Overvoltage
5.
DMX OK LED
i.
Solid GREEN – DMX signal OK
ii.
Off – DMX signal not presence
6.
DMX ERR LED
i.
Solid RED – DMX signal ERR – check cable for 2/3 inv. connection
ii.
Off – DMX signal not presence
7.
WMX LED
i.
Off / RED – WDMX device is off state by DIP switch
ii.
Fast RED/GREEN flash – device is in pairing state by WDMX TX unit
iii.
Slow RED/GREEN flash – WDMX TX unit have disconnected DMX signal
cable, or DMX signal cable is connected wrong way
iv.
Solid GREEN– WDMX signal is presence, DMX signal is OK
Summary of Contents for DP1
Page 7: ... 7 8 ...
