Model SRV712W Marine Scale System
Service Manual
Part No. MAN712W_170816
Page 9 of 14
S
Instruments, Inc.
,
600 Young Street, Tonawanda, NY 14150
Tel: 716-693-5977 Fax: 716-693-5854 URL:
email:
Copyright 2017
S
Instruments, Inc.
BASIC SYSTEM OPERATION
Ensure that the scale is free and clear of any obstructions before operating.
Press the “
DISPLAY
” button and hold it for 2-3 seconds. The display will read “0.0” and be
ready for weighing.
When a mat or pad is to be used on the scale platform, the weight of the pad must be tared out.
Place the mat on the platform, then press and hold the “
DISPLAY
” button for 2-3 seconds. The
display will read “0.0”.
Note
:
The display will automatically shut down after five minutes. The zero (TARE)
will be stored in memory.
Assist the animal on the scale platform; its weight will appear on the display.
Note
:
The display will automatically shut down after five minutes. Press the
“
DISPLAY
” button to restart.
It is recommended that the system be zeroed prior to each subject being weighed.
BATTERY REPLACEMENT
Figure 4: Battery Replacement
REPLACING BATTERIES
When battery replacement is needed, an indicator will appear on the display.
STEP 1:
Turn the platform over and remove the four screws on the Battery Cover.
STEP 2:
Remove and replace the six (6) “AA” cell batteries. Replace the screws in the Battery
Cover.
NOTE: TIGHTEN SCREWS ONLY UNTIL RUBBER SEAL STARTS TO COMPRESS
STEP 3:
Press the “
DISPLAY
” button to confirm display is working.
STEP 4:
Position the scale back into weighing position.
STEP 5:
Zero the system. Scale is ready for use.
Battery Cover
