Model SR555
i
Stand-On Scale
Operating and Service Manual
Part No. MAN555
i
_MICROBAN_201001
Page 5 of 22
S
Instruments, Inc.
,
600 Young Street, Tonawanda, NY 14150
Tel: 716-693-5977 Fax: 716-693-5854 URL:
www.srscales.com
email:
Copyright 2020
S
Instruments, Inc.
ASSEMBLY (Cont’d)
STEP 6:
(Figure 2) Lay the system on its side
and remove the Cable Clamp (4) from the Base
Assembly. Attach the Display Cable Connector
(5) to its mate from the Base Assembly.
STEP 7:
(Figure 2) IMPORTANT: Reinstall the
Cable Clamp! Slide the cable back up into the
Mast. Set the display cable into the groove under
the Cable Clamp and reinstall the Cable Clamp,
leaving just enough slack to alleviate any tension
on the Cable exiting the Platform. Securely
tighten the Cable Clamp screw. Excess cable
MUST NOT contact the floor.
STEP 8:
(Figure 3) Open the Battery Compartment cover
and install the six (6) supplied “C” cell batteries as
indicated on the cover diagram. Close the cover and
tighten thumb screw.
STEP 9:
Return the scale to the upright position.
INSTALLING AC POWER SUPPLY (SR555i-AC):
STEP 10:
Connect AC Power Supply (12) to the bottom
side of the Display Unit and plug into standard AC Wall
outlet.
STEP 11:
Press and hold
“ZERO/WEIGH”
button to set
System Zero (see directions for
SETTING SYSTEM
ZERO
).
Figure 2: Cable Clamp and Display Cable
Connector
Figure 3: Battery Compartment
Cover
Continued next page
4
5