Model SR555
i
Series Stand-On Scale
Operating and Service Manual
Part No. MAN555
i
-KG_MICROBAN_201001
Page 4 of 22
S
Instruments, Inc.
,
600 Young Street, Tonawanda, NY 14150
Tel: 716-693-5977 Fax: 716-693-5854 URL:
www.srscales.com
email:
Copyright 2020
S
Instruments, Inc.
ASSEMBLY
STEP 1:
Unpack the scale system and check
parts against the
PACKING CHECKLIST
. If
there are any missing or damaged parts, please
call the service hotline at 1-800-654-6360.
STEP 2:
(Figure 1) Verify that the serial number
on the Display Unit (1) matches that on the Base
Assembly (2).
STEP 3:
Remove the four (4) set screws from
Base Assembly collar and apply a small amount
of Loctite
to each. Insert Mast (3) into Base
Assembly collar and seat firmly. Re-install set
screws in Base Assembly collar and tighten
securely.
NOTE:
If an optional printer has been ordered,
go to Page 6
“INSTALLING OPTIONAL
PRINTER”
before proceeding.
STEP 4:
Feed the display cable down through
the Mast and pull out through the Base
Assembly.
STEP 5:
Remove the set screws from the
Display Unit collar. Set the Display Unit
squarely on top of the Mast with the display
label facing the scale platform. Apply a small
amount of Loctite
to the four (4) set screws
and reinstall the set screws, tightening securely.
#
PART NAME
1
Display Unit
2
Base Assembly
3
Mast
4
Cable Clamp
5
Display Cable Connector
6
Handrails (optional)
7
Height Bar (optional)
8
Battery Compartment
9
Printer (optional)
10
Printer Cable (optional)
11
Printer Mounting Collar (optional)
12
AC Power Supply
Figure 1: Assembly Diagram
Continued next page
7
1
2
3
6
8
9
12