6
Rappel Anchor Loops are now a standard feature on our harnesses. If you choose to use the SQRL
Rappel Slings, attach the sling to the anchor loop as in the photo below (pass the sling through the
anchor loop, then the sling through its own loop, to form a lark’s foot knot on the anchor).
The two slings should be attached with a locking carabiner. You can then use a rappel / belay
device or a Munter Hitch to rappel.
Note that it is recommended to backup all load bearing systems such as with a sling connecting
your chest strap and the locking biner. Never attempt to rappel without proper knowledge,
instruction, or guiding. The anchor loops and rappel slings are for static weight only, do not use
them as climbing harness anchors and never dynamic load these points.
RAPPEL ANCHOR LOOPS, AND RAPPEL SLINGS
INSPECTION AND MAINTENANCE
The critical junctions of the CXUL.XL are possible to inspect. All major bartacks are made with
contrasting color thread and are easily accessible. Always inspect your CXUL.XL before each use
and discontinue use immediately if you see any evidence of wear or damage. Always check
your entire container system, and all equipment, for signs of wear or degradation before every
use. NEVER ASSUME that your equipment is in perfect working condition and always use extreme
caution when trusting any single component of your equipment with your life.
Summary of Contents for CXUL.XL
Page 5: ...4...
