Keep zippers close against MLW webbing.
Handles completely exposed when skydiving.
Zippers tight against MLW.
3
3D COMPRESSION INLET
ZIPPER BUNGEES
USE, CARE, AND FEEDING OF YOUR SQUIRREL
The 3D Compression Inlet is an advanced and effective innovation,
however, it does require some care and maintenance. It is extremely
important that you do not abuse your inlets. Do not store your suit in a
tightly packed configuration. Do not store your suit folded tightly in hot
conditions. For instance, the worst thing that you could do would be to
leave it crammed into your stashbag in a hot car for a few hours - do
this, and your inlets will surely deform. In the case of inlet deformation,
massaging them into shape at or above room temperature will help
to re-form them.
The bungees that hold the zippers tight to the main lift webbing (MLW) of your harness must always
be connected.
DO NOT
jump your suit without the zipper bungees set tightly around your harness
MLW. Tying the bungees on the inside of the MLW usually results in the zippers being closer, and
the hole being smaller.
NOTE:
If you think that the zipper system is not functioning well with your skydive harness (i.e. your
emergency handles are not always 100% accessible), please contact us immediately before your
next jump. You may need to modify the zippers so that the sliders stay locked in place, as per the
information at this URL:
www.squirrel.ws/zipperstuff
