How to Record an Audio File:
●
On the device is a toggle switch.
●
On the side with the clip are two symbols (-) & (
. .
)
●
The toggle can be slid towards either of these symbols
●
If the toggle is in the middle position the device is OFF
●
If the toggle is turned towards the
( - )
the device is in
Continuous
recording mode
●
If the toggle is turned towards the
( .. )
the device is in
Voice Activated
recording mode
●
When finished recording slide toggle to the middle position to end the recording and turn
off the device
●
Wait 5 seconds before making another recording
NOTE: If the device runs out of power during the recording, it will finalize and save the
file before the battery dies
How to Playback files on the device:
●
While the device is OFF, plug in headphones into the AUX port of the unit
● Hold
down the
Play
button on the remote control for three seconds, the indicator light
will turn blue and the first recorded file will begin to play
●
Navigate between files by using the (>>)
Next
and (<<)
Previous
Button
●
Pressing the play button during playback will cause the unit to go into standby mode,
indicated by a green light. Press the play button again to continue listening to the file.
●
Hold
down the play button for three seconds to turn the unit off.
How to Set the Time/Date stamp on a PC(Windows Only):
●
Connect the device to the USB port of the computer
● Double click the
Time Setup.exe
file
● The
datetime.cfg
creator will open and press START to sync the date/time with the PC.
● A new file will be created called
date_time.cfg
● Disconnect the device from the PC and create a new recording in order to sync the date
and time.
● Reconnect the device to a PC and if date_time.cfg is not visible the date and time are
now set.
NOTE: Date and time setup can only be done on a Windows Computer