Chapter 6
SEITAL S.r.l.
Rev. 3 of 01/12/04
Page 6-6
Use and maintenance handbook: Centrifugal separator
SE 40CX
11) After carefully cleaning the grooves, insert the
nylon gasket
and the OR gasket on the
bowl hood (Fig. 6.13 and 6.14). To apply the nylon gasket, turn the bowl hood upside
down and fit the gasket over the groove; then start inserting it slightly giving blows with a
plastic hammer. This operation must be made striking, uniformly on the circumference,
the gasket in one point and after in the opposite one (180°). When
gasket
has
been
uniformly inserted, take a small piece of the older gasket and, after placing it over the new
one, give on it some plastic hammer blows until it enter of about 1 mm. under the bowl
hood surface (see Fig. 6.15).
Figure 6.13
Figure 6.14
Figure 6.15