Chapter 6
Rev. 3 of 01/12/04
SEITAL S.r.l.
Use and maintenance handbook: Centrifugal separator
SE 40CX
Page 6-3
4)
Carefully clean the groove on the
moving ram and apply the rubber
gasket (Fig. 6.5 and Fig. 6.6 - part 1)
using a plastic hammer. Inserting the
gasket, pay attention that the surface in
contact with bowl body has not shear
rags. Be sure that the external surface of
the gasket does not protrude from the
groove
5)
Smear antiscuff grease on the coupling
surfaces of the bowl hub and the
moving ram (Fig. 6.6 part 2).
6)
By the spanner (09.100.0), insert the
moving ram.
Proceed as explained
below.
- Fasten spanner body (l) on the
moving ram.
- Slightly screw threaded rod (2) until
the threaded part length outside the
spanner body is 4
5 mm.
- Lift the moving ram by hand or by
hoist and place it down on the bowl
body (fig. 6.7).
- Take care that the “0” marks of the
two pieces are aligned, so that the
three guide pins of the moving ram
enter
correctly
into
the
corresponding holes in the bowl
body.
Figure 6.6
Figure 6.5
2
1
Figure 6.7