Chapter 4
SEITAL S.r.l.
Rev. 1 of 14/01/97
Page 4-2
Use and maintenance handbook: Centrifugal separator
SE 40CX
LIFT TRUCK
Use a lift truck with:
•
capacity higher than the weight of the packing (reported outside the
case);
•
forks with length higher than 1500 mm.
Insert the forks under the level ground in central position, where signed by the suitable
triangles on the case (fig. 4.1), and keep them at the maximum distance one from the other.
SLING
Must be used ropes or bands in good conditions (neither damaged nor deteriorated) having
guaranteed capacity higher than the weight of the packing (reported outside the
case).
Pass the two ropes outside the “case feet” to avoid the sliding of the ropes towards the centre
of the case (fig. 4.2).
4.4.
Lifting and transport of the machine without packing
ATTENTION
Danger of damaging the machine during transport
The machine transport on the road must be performed without the bowl to avoid damaging of
the vertical shaft and/or ball bearings.
To lift the preassembled unit on base frame
(fig. 4.3), use a lift truck having guaranteed:
-
capacity higher than the weight of the machine (ca. 1.700 kg.);
-
fork with length higher than 1.500 mm.
Insert the two forks (fig. 4.3) from the side A of the base frame in such a way that they reach
the edge of the opposite side, or insert them from the side B (motor side) with the caution of
Figure 4.2
Figure 4.1
