1
© SPX FLOW, Inc.
Form No. 102696
Rev. 2 Sept. 21, 2016
MODELS D & F
AIR HYDRAULIC PUMP
with Automatic Valve
Max. Capacity: 10,000 PSI
l
Carefully inspect the pump upon arrival. The carrier, not the manufacturer, is responsible for any damage
resulting from shipment.
l
These instructions should be read and carefully followed. Most problems with new equipment are caused by
improper operation or installation.
SAFETY PRECAUTIONS
WARNING
l
All WARNING statements must be carefully observed to help prevent personal injury.
Hydraulic Hose
l
Before operating the pump, tighten all hose connections using the proper tools. Do not overtighten the
connections. Connections need only be tightened securely and leak-free. Overtightening may cause
premature thread failure or high pressure fittings to split at pressures lower than their rated capacities.
l
Should a hydraulic hose ever burst, rupture, or need to be disconnected, immediately shut off the pump.
Never attempt to grasp a leaking hose under pressure with your hands. The force of the escaping hydraulic
fluid could cause serious injury.
l
Do not subject the hose to potential hazard such as fire, extreme heat or cold, sharp surfaces, or heavy
impact. Do not allow the hose to kink, twist, curl or bend so tightly that the oil flow within the hose is blocked
or reduced. Periodically inspect the hose for signs of wear because any of these conditions can damage the
hose and may result in personal injury.
l
Do not use the hose to move attached equipment. Stress may damage the hose and cause personal injury.
l
Hose material and coupler seals must be compatible with the hydraulic fluid used. Hoses also must not come
in contact with corrosive materials such as creosote-impregnated objects and some paints. Consult the
manufacturer before painting a hose. Never paint the couplers. Hose deterioration due to corrosive materials
may result in personal injury.
Pump
l
Do not exceed the PSI hydraulic pressure rating noted on the pump nameplate or tamper with the internal
high relief valve. Creating pressure beyond rated capacities may result in personal injury.
l
Before replenishing the oil level, retract all cylinders to prevent overfilling the pump reservoir. An overfill may
cause personal injury due to excess reservoir pressure created when cylinders are retracted.
Cylinder
l
Do not exceed rated capacities of the cylinders. Excess pressure may result in personal injury.
l
Do not set poorly-balanced or off-center loads on a cylinder. The load may tip and cause personal injury.
Air Supply
l
Shut off and disconnect the air supply when the pump is not in use or before breaking any connection in the
system.
Operating Instructions for:
AP02528
AP02529
AP03715
PA4-ADV
PA4-HOL
PA4-MBI
PA6R-MBI
PA50-MBI
SPX Hydraulic Technologies
5885 11th Street
Rockford, IL 61109-3699 USA
Tech Services: (800) 477-8326
Fax: (800) 765-8326
Order Entry: (800) 541-1418
Fax: (800) 288-7031
powerteam.com