11
enter the normal mode; the date will not saved if turn off the printer just through pressing
【
FEED
】
button.
5.5 Steps for entering mode of upgrading program.
Power off, open
【
Printer Roller
】
and press the
【
FEED
】
button; restart the machine and release
the button after the light is on;press
【
FEED
】
button five times and close
【
Printer Roller
】
; Then
the printer enters the mode of upgrading; at this time, light flashes at rate of about one second
5.6 Paper loading
Steps for setting automatic feeding paper are as following:
Connecting the power,ensure the cabin side of paper roll is up and broken section of paper is
smooth.Put the paper into the paper exit and head roller will take it in automatically, as following
Fig 5-1
Fig5-1procedure of the automatic feeding paper
5.7 Exclusion measures for paper jam
Unscrew knurled screw M3.0, removed head bracket for EU58 III - and the head, cutter and PBC
board installed on it from the main bracket for EU58 III,.Lift the cutter to open on the paper lever,
after removing the jammed paper, then put down on paper lever to put down the cutter,
troubleshooting is complete.Now you can re-install.
Side of cabin
Paper exit
