OPERATING MANUAL
MN-SST70
ED-19-01
SPRIANO® TECHNOLOGIES
- www.spriano.it – [email protected]
a TERRANOVA® Srl brand
- www.terranova-instruments.com - VAT IT07848810151
Factory & Sales: Via Gramsci 1 – 26827 Terranova dei Passerini (LO) – Italy
Head Office: Via Rosso Medardo 16 – 20159 Milano – Italy Ph: +39 0377 919119 – Fax: +39 0377 855720
Pa
g.
7
/52
3
INSTALLATION
3.1
T
RANSMITTER
I
DENTIFICATION
Transmitter data can be found on the nameplate fixed on the top of transmitter enclosure (see
). The Serial Number must be quoted at the occurrence of a specific request to the
manufacturer.
3.2
G
ENERAL
M
OUNTING
R
EQUIREMENTS
Prior installation shall be observed following considerations:
-
Check whether Transmitter’s operating conditions are within the limits as reported in the
nameplate, technical specifications sheets and/or label;
-
Make sure that the operating conditions are compatible with the specification given to the
manufacturer.
M
ANDATORY
!
-
For measurement in the presence of particularly hot liquids (e.g. steam) make
sure that the Transmitter is supplied with a suitable finned arm.
-
For viscous liquids or those containing solid particles in suspension make sure
that the connection to the process is a suitable one in order to avoid clogs.
W
ARNING
!
Direct sunlight may cause serious damages to the instrument.
Never install standard Transmitter under the sun or in any other location which
could cause direct overheating through radiation.
Figure 2: mounting requirements
DIRECT SUNLIGHT
SUNSHADE
PROTECTION
ZONE 1
ZONE 0
