SAFETY INSTRUCTIONS
1.
ALWAYS WEAR SAFETY GOGGLES AND PROTECTIVE GLOVES WHILE OPERATING FOAM UNIT.
2.
AVOID CONTACT OF CLEANING AGENT WITH SKIN AND EYES. IF CONTACT OCCURS RINSE AFFECTED AREA
WITH WATER FOR 15 MINUTES AND GET MEDICAL ATTENTION IF NEEDED.
3.
AFTER USE, RELIEVE ALL REMAINING PRESSURE IN THE SYSTEM BY UNPLUGGING THE AIR LINE FROM THE
UNIT (ITEM# 23) AND OPENING THE DISCHARGE BALL VALVE (ITEM# 5).
4.
NEVER POINT THE DISCHARGE WAND AT ANYONE.
SET-UP INSTRUCTIONS
1.
REMOVE ALL PARTS FROM SHIPPING BOX.
2.
CLIP THE CABLE TIE HOLDING THE COTTER PINS (ITEM# 6) AND AXLE WASHERS (ITEM# 7) FROM THE LEG OF
THE CART.
3.
PLACE ONE OF THE WASHERS (ITEM# 9) ON ONE OF THE AXLES, THEN SLIP A WHEEL (ITEM# 11) ON THE AXLE
FOLLOWED BY A SECOND WASHER. THEN INSERT A COTTER PIN (ITEM# 8) INTO THE HOLE IN THE AXLE AND
BEND THE COTTER PIN TO KEEP IT FROM FALLING OUT. REPEAT THIS FOR THE OTHER SIDE.
OPERATION INSTRUCTIONS
1.
FILL THE DRUM WITH DESIRED COMBINATION OF CHEMICAL AND WATER.
2.
PLUG AN AIR LINE INTO THE AIR INLET FITTING (ITEM# 23)
3.
HOLD THE DISCHARGE WAND SECURELY IN HAND AND SPRAY DESIRED AREA.
WARNING: NEVER POINT THE DISCHARGE WAND AT ANYONE.
4.
RELIEVE PRESSURE FROM DISCHARGE HOSE AFTER USE.
ACCEPTABLE PRODUCTS
UNACCEPTABLE PRODUCTS
- ALKALINE CLEANERS
- ALL HYDROCARBONS
- CAUSTIC CLEANERS
- D-LIMONENE
- SANITIZERS
- ACIDS
SI-15 RM
