10106 rev. A
8
INSTRUCTIONS PART 1: Build Terrace Base Unit
STEP 1:
Set upright frames parallel, standing up, set
at the following distances:
4 Bike Single-Sided or 8 Bike Double-Sided
Module: 26.5 inches
6 Bike Single-Sided or 12 Bike Double-
Sided Extension Module: 42.5 inches
8 Bike Single-Sided or 16 Bike Double-
Sided Module: 58.5 inches
12 Bike Single-Sided or 24 Bike Double-
Sided Module: 90.5 inches
STEP 2:
Install the inside connecting bar at the rear
of the upright frames.
Orient the part as shown in the image with
the hole closest to the upright frame on the
right.
NOTE:
If installing a single-sided module,
the part is not symmetrical, therefore the
correct orientation is critical (refer to image
and the placement of holes). For double-
sided modules, the part is symmetrical and
can be installed in either orientation.
For any module type, the hex nuts should be
on the bottom of the part when installed.
Thread four (4) 5/8” long 3/8-16 hex bolts
and washers. DO NOT fully tighten fasteners
as realignment may be necessary.
