TRAMPOLINE ASSEMBLY
Frame Assembly
1.
As there are three different types of top rail tubes, it is very
important to lay out the parts on a clear dry level surface to
form a loop as shown in Figure 1.
The top rail tubes (A, B & C) should form a circle, with the
spring hole eyelets facing upwards.
A T-joint (G) should be placed between top rail A & A
sections.
2.
To complete the Legs assembly. Connect the Vertical Leg
Tubes (D & E) with the W-Shape Leg Tube (F) as shown in
Figure 2.
Align holes, secure D, F & E with the Bolts & Washer (L) and
Long Nuts (K). See Figure 2.
3.
Make sure on T-joint (G) and top rail tubes (B & C), the side
with welded socket should face outward to the trampoline.
Connect the Top Rail Tube (A) by sliding the
wider end of the
tube
into the T-Joint (G) first. Then connect the Top Rail
Tubes (B & C) to form the top rail loop as shown in Figure 3.
If standing on the outside of the circle created in step 1, the
wider end should be on your left hand side. Slide the
SMALLER END
(right hand side) of the
next Top Rail tube into the T-Joint and follow this process around the trampoline to
form the
top rail loop.
Push each section firmly to ensure both ends of the rail pieces are firmly in position within the
T-Joint. Please see Figure 3.
4.
Connect the completed Leg Tubes to the Top Rail Loop as
shown in Figure 4. Ensure spring loaded locking pins are
aligned with locking holes and pin locks into position.