IP Video Intercom Paging Console User Manual
43
Fault exclude
IP Video Intercom Paging console can not log in to the server normally
？
1. Check if the service software and the main control unit are normally turned on. Before you open the service software, you
need to turn off all firewalls (including the firewall that comes with the system and other firewalls included in the anti-virus
software).
2. Check if the network connection is normal. After the terminal is powered on, the green indicator of the network port is
always on. At the same time, the orange indicator light flashes briefly or rapidly, indicating that the network cable is hardwired. If
the green indicator of the network port is not lit, there is a problem with the hard connection of the network. Check the network
cable and switch connected to the terminal to see if it is working properly, damaged or badly connected.
3. Check the IP settings of the terminal. Check whether the terminal ID, service IP, local IP, server port, and gateway IP are
set correctly.
The video of IP Video Intercom Paging Console can not be saw during intercom?
1. Check whether the display video in the function parameters of the IP video intercom paging console is open or not.
2. Adjust the camera angle of the IP video intercom paging console. Select local video in the settings to check whether there
is video. If there is no video, please adjust the angle of the camera until the video screen appears;
3. Check whether the video of IP video intercom paging console in the intercom has been closed.
No dial pad?
1. Select the function parameters in the settings and turn "Show dial pad" on.
2. Check whether the dial pad is closed in the intercom parameters on the web page
.
Display failed call target when the intercom was initiated?
This unit is not registered or the other terminal is not registered
.