91
Spohn & Burkhardt
Adjust the position of the monitor with the monitor arm (
9.2
) as follows:
The monitor rotation and tilt can be adjusted continuously by moving the monitor to the required po-
sition.
6. Servicing
Danger!
All tasks on the device are only allowed to be undertaken by specialist personnel taking
into account the relevant safety regulations. Always pay attention to the safety instruc-
tions in
6.1. Control stand
Servicing measure
Interval
Function test
Before starting work
Visual inspection/cleaning
Regularly
Checking screw joints
After the first 200 operating hours,
then every 6 months
Lubricate slewing ring
Every 3 months
Check cables in the slewing range
At least every 3 months and as required
6.1.1. Visual inspection
Danger!
Damaged control stands are not allowed to be operated.
1. Check the entire control stand and its components for soiling.
• If necessary, remove any soiling.
2. Check the control stand and its components for damage:
• Take damaged control stands out of operation.
• Replace damaged components,
(see chapter 7. “Repair”, page 93).
6.1.2. Function test
Danger!
Damaged control stands are not allowed to be operated.
1. Check the adjusting functions of the control stand SV1C as per
chapter 5. “Operation”, page 83.
• If you are not able to operate one of the adjusting functions, take the control stand
out of operation and contact
Spohn & Burkhardt GmbH & Co. KG
(
for address
2. Check the functions of the control stand SV1C as per the requirements of the operating organiza-
Summary of Contents for SV1C Series
