Installation and Maintenance Manual
System Configuration
Installation and Maintenance Manual v4/0615/10
73
2
Run (double click) the set up file called, for example, PCS60_MAC.3.2.67.pkg
3
At the Welcome screen select Continue to start the installation
4
At the Select a Destination screen select the Volume where you want the software loaded
5
By default the software will be loaded into the Applications folder. Change this location if required.
6
Select Continue when ready
7
At the Standard Install screen select Install. (If you wish at this point to change the Install Location
select Change Install Location.)
8
You will be prompted for your PC log in password, enter this in the Password field.
9
The software will be installed
10
At the Installation Completed screen select Close
PCS 60 as an IP Soft Phone on an Apple Mac PC
The PCS 60 software can be run as an IP soft phone where the PC becomes the User
’s telephone and the
voice path will be via the PC. Therefore the PC will require a headset, microphone, sound card etc
installed.
Before starting:
x
The PC must have a network connection to a Call Server.
x
An IPUser licence must be previously installed and be available. (For further details please refer to
page 20.)
Running the PCS 60:
1
Run the PCS60 software either from Applications or create an Alias to this file in the required
location and double click on the Alias.
2
The PCS 60 application will open.
3
The “Searching for Server” message will be displayed as the registration process on the Call Server
is started.
If the “Searching for Server” message remains and the PCS 60 does not continue to the next step
check that the PC can communicate with the Call Server or refer to the Connect to the Call Server
Remotely section below.
4
The “
No Licenses Available
” message will be displayed
while the phone is registered as described
in step 5.
5
If the Auto Add Phones feature is turned on the Call Server will automatically register the PCS 60.
(Please refer to page 13 for further details.)
If the Auto Add Phones feature is turned off:
a
In Manager select Unassigned Phones
b
The hardware address of the PC will identify the PCS 60 to be connected. Click on the entry
required. (If the PCS 60 is not listed check the installation of the IPUser licence as detailed
from page 20.)
c
From the Status list box select Member
d
Select Update when ready
e
The PCS 60 will now appear under Phones, identified by the hardware address of the PC
6
The “Security Access Denial” message will be displayed while an IPUser licence is assigned
7
A User account will be automatically created configured with the next available extension number.
This User will be assigned to the PCS 60, the “Security Access Denial” message will disappear and
the PCS 60 will be ready for use. The name of the assigned User will be displayed in the Status Bar
at the bottom left hand corner of the PCS 60.
