How to install
glass splashbacks
What you need
Before you start
Easy to apply
STANDARD INSTALLATION
PEEL, STICK & SEAL
Tape Measure
Check that your splashback
fits into the required space.
Your splashback must be at
least 110mm away from the
nearest heat source.
Make sure all corners are safe from
hard surfaces. Take care to peel off
the protective film back and
not
the self-adhesive backing.
Place the bottom edge of the
splashback to the rear of the hob.
Push it to the wall and apply firm
even pressure with the cloth.
Using the Silicone Sealant.
No more than 2.5mm in thickness.
Our splashbacks
are made from
toughened safety
glass so they
cannot be cut.
Check the surface
is perfectly flat,
non-porous, dry
and dust free.
Splashback to
go here
Silicone Sealant -
Low Modulus Type
Sealant Gun
Clean Cloth
1 x Splashback
1
Peel off backing
1
Stick on the wall
2
Seal the edges
3
2
3
110mm
