SPL-Laboratory Next-Lab, Manual

Page: 7 / 9

6
Running Smart-Config procedure
At once (not later than in 2 seconds) after activation of Smart-Config mode on the device, start the
Smart-Config procedure on your tablet PC/smartphone. For that press
Smart-Config button (Android) or
Start (iOS).
After the operation is finished you will see relevant text either on the display of the device (Next-LCD),
or in the software on the PC, or the Power indicator will blink 5 times. For stopping the operation on
Android tap the display of the device.
If you see the text Smart Config timeout , repeat the operation until the text Smart Config Finished
appears on-screen.
The module connection status can be checked in Wi-Fi Settings-Wi-Fi Status menu (Next-LCD) or in
Measuring Center software.
Please note that:

The Wi-Fi module might require some time (1-2 minutes) for connecting.

If the module is unable to connect within 2 minutes, it goes into sleep mode, and for
reconnecting the module the device has to be restarted.

In some cases for successful connection the Wi-Fi access point/PC/smartphone/tablet PC should
be restarted.
Configuration of the Wi-Fi module through the interface in Next-LCD device
This function is available in the later versions of Next-LCD device microcode. If you are unable to enter
Wi-Fi Settings mode on your device, download the latest microcode version from “ Support ” section of
the www.spl-lab.ru website and run the update for your device according to the instruction given in the
archive with firmware upgrade.

Start the device and wait until it is completely booted. Enter Wi-Fi Settings mode by pressing #2
button (Option) in CFG mode.

Select Connect to Network item. The device will carry out a search of available wireless
networks.

Select a wireless network to which you have to connect to.

If the network is password protected, enter a password, using buttons #5 and #6 to choose the
group of symbols, buttons #7 and #8 to choose specific symbol, button 4 to enter the symbol,
button #1 for deleting entered symbol, button #2 to complete entering a password and to
connect to the network.

Then the device will attempt to connect and inform about the results on-screen.

The module connection status can be checked in Wi-Fi Settings-Wi-Fi Status menu or in
Measuring Center software.
Please note that:

The Wi-Fi module might require some time (1-2 minutes) for connecting.

If the module is unable to connect within 2 minutes, it goes into sleep mode, and for
reconnecting the module the device has to be restarted.

In some cases for successful connection the Wi-Fi access point/PC/smartphone/tablet PC should
be restarted.