CUSTOMER SERVICE 1-888-707-1180
7 MAURICE PINCOFFS CANADA©2009
STEP 2: CONSOLE MAST ASSEMBLY
1.
Locate the Console Mast (12) and Console Mast Cover (49) and slide the Cover (49) onto the Mast (12) as
far as it will go. Make sure the Console Mast Cover (49) is facing the correct way.
2.
At the top opening of the Main Frame (1) of the elliptical is a Computer Cable (39). Unravel and
straighten out the Computer Cable (39) and feed it into the bottom of the Console Mast Tube (12) and out
of the top opening.
3.
Install the Console Mast (12) into the receiving bracket in the top of Main Frame (1).
NOTE: there is one bolt already installed in the receiving bracket that will engage with the slot at the
bottom of the Console Mast (12). This needs to be tightened at the end along with the three other console
mast bolts.
4.
Put the 1 pc of 3/8"
×
2T Sprit Washer (128) onto the 1 pc of 3/8"
×
2-1/4" Hex Head Bolt (75) and the 2pcs
of 3/8"
×
23
×
2.0T Curved Washers (104) onto the 2pcs of 3/8"
×
3/4" Hex Head Bolts (76). Install, and
tighten, the Hex Head Bolt (75) through the left side of the receiving bracket into the Console Mast (12).
NOTE: There is an electrical wire (39) running through the Console Mast Tube (12). Be careful not to
damage or pinch this Computer Cable (39) during this procedure. Damage to the Console (32) could result.
Install, and hand tighten, the 2pcs of 3/8"
×
2/4" Hex Head Screws (76) through the front of the receiving
bracket into the Console Mast (12).
5.
Use the 13/14 m/m Wrench (124) and Consolidating Allen Wrench & Phillips Head Screw Driver (125) to
tighten the three bolts, together with the preinstalled bolt, firmly. These bolts should be tightened as much
as you possibly can.
6.
There are two electrical wire connectors at the top opening of the Console Mast (12), one Hand pulse
Cable (44), one Computer Cable (39). Connect these to the corresponding connectors on the back of the
Console (32). The connectors are keyed so you cannot plug them in the wrong way so do not force them.
7.
Store the excess wire back into the Console Mast (12) and carefully install the Console (32) onto the
mounting plate of Console Mast (14) and secure by using the 4pcs of M5
×
12 m/m Philips Head Screws
(84).
