Sperry Marine Visionmaster FT ECDIS, User Manual

Page: 402 / 531

Electronic Range and Bearing Lines ECDIS User Guide
9-6 65900012
To re-position the ERBL back to own ship's CCRP
either right click on EBL button and select
Centre
Origin from the drop down window, or right click
on the ERBL dot and select Centre EBL / VRM
from semi-transparent window.
Where Drop End Point (E) is selected from the EBL readout:
1. The EBL and VRM buttons are shown with the
suffix (E) . As the ship moves, the ERBL range
and bearing are continually updated to the
dropped end point.
2. To move the line or marker relative to own
ship with the ERBL range and bearing static select Carry End
Point (C) .
3. Or to drop the ERBL at the current position select Drop Origin (D)
from the drop down window, or right click on the EBL origin and
select
Drop EBL / VRM.
Dropping an EBL/VRM on the Display
An EBL/VRM may be dropped at any position
on the chart display.
To drop an ERL/VRM right click at the required
location and select
Adjust EBL/VRM1 from
the context window. An EBL and VRM are
created at the location, after a short period of
time the EBL and VRM display the previously
maintained settings
The range and bearing of the ERBL can be
adjusted on the display by moving the
trackball.