Sperry Marine NAVIKNOT 600 SD, Operation, Installation And Service Manual

Page: 90 / 256

056353/J NAVIKNOT 600 SD
3-32 Alert Codes and Messages
Alerts (ALF-ALC-ARC/ACN) / Prop. BAM Alerts Active
Table 3-2:
NAVIKNOT 600 SD alerts
(ALF-ALC-ARC-ACN /
prop. BAM alerts active)
Note If NMEA messages ALF-ALC-ARC/ACN are selected for alert manage-
ment, all NAVIKNOT alerts are category B alerts according to IEC 62923.
Note In case the proprietary BAM alert setting is ACTIVATED and the
NMEA Messages ALF-ALC-ARC/ACN (BAMS) are selected for the alert
management, all four digit alert IDs (30xx) are incremented by „10000“,
making this NAVIKNOT alerts PROPRIETARY.
Alert
ID Alert
Inst. Alert
Prio Alert
Title Alert
Description Corrective Action
10020
1 1 A SW mis-
match CDU software
update
required Update CDU soft-
ware.
13008* 1 W Lost
COG/
SOG Check com-
munication
with antenna Check that the GPS
antenna is operat-
ing;
check cabling
between the GPS
antenna and NAVI-
KNOT electronics
unit.
13008* 1 W Lost
COG/
SOG Not enough
satellites in
view
3062 1 W Antenna
fault Antenna init
failed, restart
required Restart system
13008* 1 W Lost
STW Check com-
munication
with Preampli-
fier (SRD) Check that the pre-
amplifier D is oper-
ating;
check that protocol
is set to NMEA;
check cabling
between preampli-
fier D and NAVI-
KNOT electronics
unit; check cabling
between trans-
ducer and preampli-
fier D;
check transducer
for proper opera-
tion.
13008* 1 W Lost
STW Check com-
munication
with Preampli-
fier D
13008* 6 W Lost
STW Check dop-
pler trans-
ducer and
signal quality Check doppler
transducer func-
tionality and signal
quality.