Sperry Marine 4914-CA, Operation, Installation And Service Manual

Page: 155 / 192

k^sfd^q u jh N MRSPQPLc
pÉíìé=~åÇ=`çåÑáÖìê~íáçå=q~ÄäÉë ufff
^ééÉåÇáñ
^ pÉíìé=~åÇ=`çåÑáÖìê~íáçå=q~ÄäÉë
The following Setup and Configuration Tables (blank forms) are to be
used for recording all parameter settings for archiving purposes and for-
being able to re-enter them manually, if required.
The Installation Checklist / Record Sheet is mandatory to successfully
finish and record the installation procedures of the NAVIGAT X MK 1 sys-
tem
aÉëáÖå~íáçå aê~ïáåÖ=kçK
NAVIGAT X MK 1: Preferred Operational Settings 4914-0125-01
NAVIGAT X MK 1: Setup Table 4914-0125-02
NAVIGAT X MK 1:
Magnetic Compass Calibration Table 4914-0125-03
NAVIGAT X MK 1:
Installation/Overhaul Checklist & Record Sheet 4914-0125-10
Gyrocompass Installation Kit Mod 7
074695-0000-000 4914-0126-00
Gyrocompass Installation Kit Mod 10
074696-0000-000 4914-0126-01
Gyrocompass Installation Kit Mod 10/3
022638-0000-000 4914-0126-04
`^rqflk
Risk of loss of parameter settings through software exchange
It cannot be guaranteed that parameter settings in the User and Setup
menus and the entries made in the Magnetic Compass Calibration table
are left intact when the software is exchanged.
After installation of the NAVIGAT X MK 1 and before any exchanging the
system software IC, record all parameter settings in the setup and config-
uration tables to be able to re-enter them manually, if required.
kçíÉ It is advisable to copy the blank forms of the Setup and Configuration
Tables to have editable blank forms at hand for recording purposes.
Archive filled-out Setup and Configuration Tables and keep them togeth-
ter with the system manual in a wellknwon, readily available location
nearby the NAVIGAT X MK 1.
kçíÉ After installation of the NAVIGAT X MK 1, please return a filled-out copy
of the Setup Table to Sperry Marine for inclusion in the ship’s file.
When permanent changes are made to the system configuration, please
return an updated copy of the Setup Table to Sperry Marine.