Sperry Marine 4914-CA, Operation, Installation And Service Manual

Page: 140 / 192

MRSPQPLc k^sfd^q u jh N
NMJO oÉéä~ÅáåÖ=pçÅâÉíÉÇ=f`ë
bñÅÜ~åÖáåÖ=íÜÉ=Ñä~ëÜJãÉãçêó=f`
NMKO oÉéä~ÅáåÖ=pçÅâÉíÉÇ=f`ë
While all socketed ICs may be easily exchanged, it will mostly be impos-
sible for field service personnel to trace back malfunction of the system
to the failure of a given IC, such as an UART or PAL.
In case of failure of an RS-422 serial data output, however, the reason is
mostly a defective driver IC.
The RS-422 serial data outputs use standard quadruple RS-422 line driv-
ers (MC3487).
kçíÉ
The flash-memory IC is a 32-pin PLCC chip. A suitable extractor tool is
required to remove the IC from its socket.
Verify that a new flash-memory IC, stock no. 26562, containing software
4914-1290-00 with the required revision identifier and release date has
been obtained.
1. While the system is running, take notes of the current settings in the
Manual Settings, User and Service Setup menus.
2. Check that all the menu settings have been entered correctly into the
setup tables in the appendix of this manual. If necessary, correct and
amend the tables.
3. Power down the system.
4. Make sure that both the main and backup supplies are switched off
and efficiently safeguarded against accidental switching-on.
5. Remove the cover from the compass housing.
6. Remove the currently installed flash-memory chip (IC 34) from its
socket on the master PCB.
7. Insert the new flash-memory IC into the socket.
8. Re-attach the cover to the compass housing.
9. Power up the system.
10. Re-enter all settings in the Manual Settings, User and Service Setup
menus, as previously noted in the setup tables in the appendix of
this manual.