© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
5
512063
Installing the Dryer
Step 1: Position and Level the Dryer
Install dryer before washer. This allows room for
attaching exhaust duct.
Select a location with a solid floor. Dryers installed in
residential garages must be elevated 18 inches (46 cm)
above the floor.
No other fuel burning appliance should be installed in
the same closet with the dryer.
The dryer must not be installed or stored in an area
where it will be exposed to water and/or weather.
The dryers needs sufficient clearance and an adequate
air supply for proper operation and ventilation, and for
easier installation and servicing. (Minimum clearances
are shown below).
Figure 2
DRY2053N
**NOTE: For new installations, locate top of wall vent 42 inches (106.7 cm) above floor to make venting
easier to connect.
DRY2060N
E
E
A
A
D
OUTER WALL OF
ENCLOSURE
FRONT VIEW
SIDE VIEW
C
B
Area
Description
Closet Installation
A
Dryer sides and rear clearance
0 in. (0 cm)
B
Dryer top (Rear 24 in.)
12 in. (30.5 cm)
C
Dryer rear
.4 in. (10.2 cm)
D
Dryer Top (Front 4 in.)
.5 in. (1.3 cm)
E
Exhaust duct clearance to combustible material 2 in. (5.1 cm)
