SpectraLink 8400 Series, Deployment Manual, Page: 40 / 134

Polycom® SpectraLink® 8400 Series Wireless Telephone Deployment Guide
30
2
Edit the file to use the network configuration file you created above.
Part II: Initial Provisioning of the Handsets
Initial provisioning of each SpectraLink 8400 Series handset requires:
• A physical USB connection between the handset and the WCS as shown in
Enable the Handset’s Network Capabilities on page 12 .
• Setup of the handset’s network connection parameters. See Set Up the
Handset’s Network Parameters on page 14 .
To perform the initial provisioning of the handset:
1
Plug the USB cable between the phone (micro USB plug) and the WCS.
2
Reboot the handset to change the network configuration.
After the handset reboots and picks up the information from the network
configuration file, it should be connected to the wireless network and be
ready for the next provisioning step.
Part III: Setting Up the Provisioning Server
Next, you must set up the provisioning server to update the remainder of the
configuration parameters.
For organizational purposes, Polycom recommends configuring a separate log
file directory, an override directory, a contact directory, and a license
directory, though this is not required. The different directories can have
different access permissions. For example, you can allow LOG, CONTACTS,
and OVERRIDES to have full read and write access, and LICENSE to have
read-only access.