Spectracom VelaSync 1225, User Manual

Page: 41 / 272

2.5 Basic Connections Setup
This section is designed to take your through the initial setup steps in order to allow you
to communicate with and configure your VelaSync.
Figure 2-4:
VelaSync rear panel
2.5.1 Connecting the GPS Antenna
For instructions on how to install a GPS/GNSS antenna , the signal cable , and accessor-
ies such as surge protectors , weatherproofing kits , or amplifiers , refer to the Install-
ation Guide that came with the respective equipment.
For additional information regarding the GPS antenna location selection, see "Choosing
a GNSS Antenna Location" on page 235 .
1. Connect the GPS/GNSS antenna to the GNSS RF connector (see illustration
above, item number 7), using the supplied Type-N adapter cable, and an LMR-400
equivalent cable with surge suppressor and active GPS L1 antenna, such as Spec-
tracom model 8230.
Note the GNSS receiver connection provides 5V
DC
power for the antenna.
2.5.2 Connecting Power
Before connecting power to the unit, make sure that you have read all safety inform-
ation detailed in section
"YOUR SAFETY" on page 17 .
DANGER! When installing the product, use only the provided or des-
ignated power cables. Using any other cables and adaptors could cause
a malfunction or a fire.
2.5 Basic Connections Setup
CHAPTER
2
•
VelaSync User's Manual Rev. 3 29