Spectracom VelaSync 1225, User Manual, Page: 149 / 272

Note: A self survey will take at least 2000 seconds (33 minutes).
Relocating VelaSync
The Delete Position command may need to be used if a VelaSync system is physically
moved, and it did not self-initiate a new survey automatically. Note that neglecting to
delete the old position data and discover the new position data will cause VelaSync not
to go into synchronization state.
Sanitization
The Delete Position command must also be used when sanitizing a VelaSync unit
(ensuring that no trace of position data remains on the unit).
Deleting the GNSS position
To delete the GNSS position:
1.
Disconnect the GNSS antenna from the VelaSync unit (this is required only when
sanitizing the unit).
2.
Navigate to Interfaces > References: GNSS Reference .
3.
Click on the GEAR button next to the GNSS Reference (typically, there is only one
reference, numbered "0"). The
GNSS 0 window will open:
Locate the Delete Position box, check it, and click Submit.
4.
VelaSync will initiate a GNSS self survey.
Note: In Mobile Receiver Mode it is NOT possible to delete the pos-
ition and start the GNSS survey. This feature is only available in Stand-
ard Mode and in Single Satellite Mode . In Single Satellite Mode a GNSS
survey may take up to 24 hours.
3.3 Managing References
CHAPTER
3
•
VelaSync User's Manual Rev. 3 137