Pin
Signal
Pin
Signal
10
IRIG AM Input +
23
Ground
11
IRIG AM Input -
24
IRIG DCLS Input -
12
IRIG DCLS Output -
25
IRIG DCLS Input +
13
IRIG DCLS
26
Ground
Table 4-1:
Timing connector pinout
For additional information refer to "Accessories" on page 38.
4.2
External GNSS Connector Pinout
If your TSync-PCIe card is configured for an external GNSS receiver, a Mini-DIN-8 connector is
used for signal transmission. The provided adapter cable (see illustration below) connects the
cable of the external receiver with the GNSS connector of the TSync-PCIe card.
Figure 4-2:
GNSS receiver adapter cable
See table "Adapter pinout, ext. GNSS receiver" on the next page for adapter pinout ref
erence.
Signal
END "A"
END "B"
+12 V
3
1
GND
5
2
4.2 External GNSS Connector Pinout
CHAPTER
4
•
Instruction Manual XYZ
Rev.
R
19
Summary of Contents for TSync-PCIe
