Spectracom GSG-5 series, User Manual With Scpi Manual

Page: 32 / 378

1.
After making sure that the power cord has been unplugged, carefully turn the unit upside
down.
2.
Temporarily remove the two rear feet by loosening their screws.
3.
Remove the four housing screws and plugs (if present) at the side panels; discard them.
4.
Grip the front panel with one hand, while pushing at the rear with the other hand. Pull
the unit out of its housing.
5.
Remove the four bottom feet from the housing, as shown in the illustration below:
Use a screwdriver or a pair of pliers to remove the springs holding each foot, then push
out the foot.
Figure 2-3:
Preparing the GSG unit for rack mounting
6.
Gently push the unit into its housing again.
7.
Re-assemble the two rear feet .
8.
Install the
ears
that came with the
rack-mount kit
. Use the
rack-mount kit
M5
housing
screws .
Figure 2-4:
Part identification: ears
16
CHAPTER
2
•
User Manual GSG-5/6 Series Rev. 26
2.3 Mechanical Installation