Spectracom GSG-5 series, User Manual With Scpi Manual

Page: 233 / 378

6.3 Command Reference
6.3.1 Common Commands
6.3.1.1 *CLS
Clear Status Command
The
*CLS
common command clears the status data structures by clearing all event registers and
the error queue. Also possible executing of scenario or signal generator is stopped. It does not
clear enable registers and transition filters. It clears any pending *WAI, *OPC, and *OPC?.
Example
*CLS
6.3.1.2 *ESE
Standard Event Status Enable
Sets the enable bits of the standard event enable register. This enable register contains a mask
value for the bits to be enabled in the standard event status register. A bit that is set true in the
enable register enables the corresponding bit in the status register. An enabled bit will set the
ESB (Event Status Bit) in the Status Byte Register if the enabled event occurs.
Command Syntax
*ESE <decimal>
Parameters
<dec.data> = the sum (between 0 and 255) of all bits that are true.
Event Status Enable Register (1 = enable)
Bit Weight Enables
7 128 PON, Power-on occurred
6 64 URQ, User Request
5 32 CME, Command Error
4 16 EXE, Execution Error
3 8 DDE, Device Dependent Error
6.3 Command Reference
CHAPTER
6
•
User Manual GSG-5/6 Series Rev. 26
217