Spectra Verde 4U, User Manual, Page: 183 / 244

Appendix B — HotPair Setup and Configuration Power On the Primary Master Node
September 2017 User Guide — Spectra Verde Array
183
P
OWER
O
N THE
P
RIMARY
M
ASTER
N
ODE
To power on the primary master node , remove the front bezel, and then
gently press the power button on the front panel. The power LED
illuminates indicating that power is on. See System Status LEDs on
page 109 for more information
.
Wait while the primary master node completes its power ‐ on sequence
which takes approximately five minutes, depending on the configuration.
During the power ‐ on sequence, the array initializes all of its installed
components and starts the Verde web server.
Notes:

Do not use the array’s front panel power button to power off
the array. See Reboot or Shut down a Verde Array on
page 118 to reboot or shut down the array.

Do not power on the secondary master node at this time.
Powering on the secondary master node is the final step in
the HotPair setup.
Figure 140 Press the power button.
Power
Power LED
button
Important
Powering on the secondary master node before instructed causes the HotPair
configuration to fail.