64
If you choose
Automatic
, the receiver will find by itself
which of its ports are used to acquire the two sets of
corrections.
If you choose
Manual
, you need to specify these two ports.
The “
BRV
” line defines the port routing the corrections
from a moving base allowing vector computation whereas
the “
RTK
” line defines the port routing the corrections
from a static base allowing position computation.
• Additionally, in the
Other Settings
section, you may change
the primary GNSS system used (
GPS
is the default
selection), limit the level of position accuracy to less than
what the receiver can actually achieve in this case.
Typically you will choose
RTK Position
to match with the
selected operating mode.
• Select the model of dynamics that suits the movement
pattern of your rover best.
• Click
Configure
.
• Set the device used by the receiver to acquire the two sets
of corrections:
–
If corrections are received via radio, go to
Receiver
>
Radio
to enter all radio parameters. You may use the
internal radio or an external radio.
–
If corrections are received over the Internet, go to
Receiver
>
Network
to set the device used (this may be
Ethernet, Modem or WiFi; more information about how
to set up theses devices can be found in the relevant
context-sensitive Help). Then go to
Receiver
>
I/Os
to
start data reception in NTRIP or Direct IP mode.
